Hydraulic Cylinders - Type III - ISMT Limited
Hydraulic Cylinders - Type III
These are hot finished tubes suitable for the manufacture of hydraulic cylinders where the inside surface will first be turned and then honed to obtain the finish and dimensions. Typically these tubes are used for the manufacture of large cylinders with heavier wall thickness.
Size Range & Dimensional Tolerances
Eccentricity
| Outside Diameter | Eccentricity | ||
| All Sizes | 0.10 | Eccentricity**= | (WT max - WT min) |
| (WT max + WT min) | |||
** Where WT max and Wt min are measured on the same cross-section
Straightness
Straightness is guaranteed to be better than or equal to 1 mm per 600 mm.
Ovality
Ovality is guaranteed to be contained within the overall tolerances on the diameter.